Page 1 of 1
Receiver connections
Posted: Thu Feb 11, 2021 7:15 am
by Steve J
This post is not unique to the Papillion, but it is what I'm building and I didn't see a better place for it. Where do I connect the ECS and servos to the receiver? I have the WN 4 channel receiver.
Re: Receiver connections
Posted: Thu Feb 11, 2021 7:57 am
by SavageX89
On that receiver, you will see 5 sets of 3 pins. One is for the signal, one for positive, and one for negative. Each of those sets represents one of the 4 channels. Simply plug the corresponding servo to the right plug. Your esc can go in #2. Servos can go in 3 and 4. I forget which is the rudder specifically. Just make sure you have signal and power going to the right pins
See the attached picture for what pins do what. (Pulled from the WN site)
https://willynillies.com/shop/ols/produ ... compatible
Re: Receiver connections
Posted: Thu Feb 11, 2021 8:58 am
by Steve J
Thank you, Savagex89, for the quick response. Missed that tiny picture on the website. Makes sense now.
Re: Receiver connections
Posted: Thu Feb 11, 2021 9:06 am
by SavageX89
You're welcome! happy to help out!
Ya, these little receivers aren't always super clear as to what each set of pins does and which orientation the pins go. Definitely don't want to burn out a receiver on accident.
Re: Receiver connections
Posted: Thu Feb 11, 2021 9:08 am
by WillyNillies.com
Thank you guys!
This is exactly why we are building up this message board!!!! It works! Yay!!!
Sincerely,
Doug and Becky
WillyNillies.com
Re: Receiver connections
Posted: Thu Feb 11, 2021 9:16 am
by SavageX89
WillyNillies.com wrote: ↑Thu Feb 11, 2021 9:08 am
Thank you guys!
This is exactly why we are building up this message board!!!! It works! Yay!!!
Mission accomplished!