Page 1 of 1

Honker hints

Posted: Tue Aug 24, 2021 8:20 pm
by speed2004
Make sure you install the pushrods before sheeting top and bottom. Very difficult to do afterwards as the holes are tiny!

Using parchment paper under wing while building keeps it from sticking to board. Use CA sparingly as to not get a "hard spot" on the wing joint so sanding isn't uneven, especially if covering rather than painting.

Use of a spray gun to put a light coat of Minwax WATER based polyurethane and sanding will make a painted wing/fuselage much lighter as the paint doesn't soak in and warp the wing. Deluxe Materials brand EZE-dope or EZE-coat also works well for this.

Feel free to add more to this list!

Re: Honker hints

Posted: Sat Jun 10, 2023 3:56 pm
by christian
Howdy, Honkers

Wing assembly is not apparent to me. Any photos, or descriptions of procedure would be appreciated.

Re: Honker hints

Posted: Sat Jun 10, 2023 4:59 pm
by WillyNillies.com
Step by step Honker wing build video is here:

[youtube]https://youtu.be/rTEgo34-xNU[/youtube]