Semi-Symmetrical Wing build guide

Everything you will want and need to know about the WillyNillies.com Sky Tiger 250
Post Reply
kdc914
Posts: 156
Joined: Tue Feb 09, 2021 7:54 pm
Contact:

Semi-Symmetrical Wing build guide

Post by kdc914 »

Semi-Symmetrical Wing build guide
Attachments
Semi_Symmetrical_Wing_Assembly.pdf
(36.36 MiB) Downloaded 269 times
DaveWave
Posts: 5
Joined: Tue Mar 16, 2021 3:04 pm
Contact:

Re: Semi-Symmetrical Wing build guide

Post by DaveWave »

I give up, how does the center section go together? A picture would be great....

I am confused by the two different ribs that are not like any others .
One has holes and the other has a cutout for a spar?
Two half ribs seem to have cutouts for what?

In the second picture is my forward/rear spar set right for a RH wing? The notches on the left are opposite what the instructions say, but this is the only way I can see the cutouts holding the ribs.

Thanks!
St1.jpg
ST2.jpg
kdc914
Posts: 156
Joined: Tue Feb 09, 2021 7:54 pm
Contact:

Re: Semi-Symmetrical Wing build guide

Post by kdc914 »

you correctly identified the center ribs. The reason one has more holes than the other is for when you go to glue them to each other to join the wing halves. The cutout for the center spar brace ideally should be left for strength until the wing halves are completed and ready to join. As you can see, the wood there once the cutout is removed is VERY thin and won't hold up to much manipulation. Hope that helps.
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests