Hello,
I understand from previous post on this topic that the spar root angle is intended to set the proper dihedral of the wing. But I also expect I can do a less than perfect job gluing the root ribs against the spar end, throwing off the dihedral. Right now I get about 4.25" under one wing tip when the other panel is flat on the table. I'd like to check my build against the design intent. So, please, can someone tell what the intended dihedral is for the Wee Papillon?
Thanks!
Jon
Dihedral, again
Everything you will want and need to know about the WillyNillies.com Wee series Papillon
Jump to
- New Members Please Read
- ↳ Rules and Guidelines for Posting
- ↳ New Member Introductions
- ↳ NEW PRODUCTS ANNOUNCEMENTS!
- ↳ Suggestion Box
- WillyNillies.com Kit Instructions and Discussions
- ↳ 1/2A Blazer 250
- ↳ Ace Littlest Stick
- ↳ Baby Sharkface
- ↳ Barnstormer 250
- ↳ Delta 250
- ↳ Der Flugel
- ↳ Eaglet 250
- ↳ F-86ish Prop Jet
- ↳ Gentle Lady 250
- ↳ GLH 250
- ↳ Honker 250
- ↳ Honker Bipe 250
- ↳ Honker Rocket 250
- ↳ Hummer 250
- ↳ Jr. Falcon 250
- ↳ Jr. Skylark 250
- ↳ J3 Cub 250
- ↳ Mustang 250
- ↳ Pee Jay 250
- ↳ P-Wee 250 Fun Fly
- ↳ Q-Tee 250
- ↳ Quickie 100
- ↳ Rascal 250
- ↳ Shoestring Micro Racer
- ↳ Simple 250
- ↳ Sky Tiger 250
- ↳ S-Tee 250
- ↳ Stuntman 23 control line
- ↳ Super Sport 250
- ↳ Wee Duster
- ↳ Wee Hornet
- ↳ Wee Papillon
- ↳ Wee Sioux
- ↳ Wee Willy
- ↳ 1/2a Ringmaster control line
- ↳ Kit Bash/Mods/Customizations
- Other WillyNillies.com Products
- ↳ Brushless Motors
- ↳ Emax Servos
- ↳ WillyKote
- ↳ Ed's Hinge Jig
- ↳ Receivers
- ↳ Electronic Speed Controllers
- ↳ MISC other products
- MISCELLANEOUS files (3D printing, etc)
- ↳ STL files for 3d printing
- ↳ non-WN plans
- ↳ HOW-TO guides
- ↳ Spec sheets, etc (NON WN products only)
- Contests, Giveaways, and other General discussions
- ↳ Balsa 250 contest 2023
- ↳ Balsa 250 contest 2024
- ↳ Wing 250 contest 2024
- ↳ Custom Builds, Mods, Hacks, and Kit Bashes
Who is online
Users browsing this forum: No registered users and 1 guest